Rohde & Schwarz FPL1000 Manuel D'utilisation page 979

®
R&S FPL1000
SYSTem:LANGuage
SYSTem:LXI:LANReset
SYSTem:LXI:MDEScription
SYSTem:LXI:PASSword
SYSTem:REVision:FACTory
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <Address>
This command sets the GPIB address of the R&S FPL1000.
Parameters:
<Address>
Example:
Manual operation:
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator <Terminator>
This command selects the GPIB receive terminator.
Output of binary data from the instrument to the control computer does not require
such a terminator change.
Parameters:
<Terminator>
Example:
Manual operation:
SYSTem:DISPlay:LOCK <State>
Defines whether the "Display Update" function remains available in remote operation
or not.
Parameters:
<State>
Manuel d'utilisation 1179.5860.09 - 12
................................................................................................................ 975
........................................................................................................... 975
...................................................................................................... 975
.......................................................................................................... 975
........................................................................................................... 976
Range: 0 to 30
*RST: (no influence on this parameter, factory default 20)
SYST:COMM:GPIB:ADDR 18
See "GPIB Address"
LFEOI | EOI
LFEOI
According to the standard, the terminator in ASCII is <LF>
and/or <EOI>.
EOI
For binary data transfers (e.g. trace data) from the control com-
puter to the instrument, the binary code used for <LF> might be
included in the binary data block, and therefore should not be
interpreted as a terminator in this particular case. This can be
avoided by using only the receive terminator EOI.
*RST: LFEOI
SYST:COMM:GPIB:RTER EOI
See "GPIB Terminator"
ON | OFF | 0 | 1
OFF | 0
The function remains available.
Remote commands
Configuring the R&S FPL1000
on page 574
on page 575
979 979