Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
TRIGger[:SEQuence]:SLOPe
TRIGger[:SEQuence]:SOURce
TRIGger[:SEQuence]:TIME:RINTerval
TRIGger[:SEQuence]:DTIMe <DropoutTime>
Defines the time the input signal must stay below the trigger level before a trigger is
detected again.
Parameters:
<DropoutTime>
Manual operation:
TRIGger[:SEQuence]:HOLDoff[:TIME] <Offset>
Defines the time offset between the trigger event and the start of the sweep.
A negative offset is possible for time domain measurements.
For the trigger sources "External" or "IF Power", a common input signal is used for both
trigger and gate. Therefore, changes to the gate delay will affect the trigger offset as
well.
Parameters:
<Offset>
Example:
Manual operation:
TRIGger[:SEQuence]:IFPower:HOLDoff <Period>
This command defines the holding time before the next trigger event.
Note that this command can be used for any trigger source, not just IF Power
(despite the legacy keyword).
Note: If you perform gated measurements in combination with the IF Power trigger, the
R&S FPL1000 ignores the holding time for frequency sweep, FFT sweep, zero span
and I/Q data measurements.
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
................................................................................................... 780
................................................................................................ 780
.................................................................................... 781
Dropout time of the trigger.
Range:
0 s to 10.0 s
*RST:
0 s
Default unit: S
See
"Drop-Out Time"
on page 346
For measurements in the frequency domain, the range is 0 s to
30 s.
For measurements in the time domain, the range is the negative
sweep time to 30 s.
*RST:
0 s
Default unit: S
TRIG:HOLD 500us
See
"Trigger Offset"
on page 346
Remote commands
784
784
Publicité
