®
R&S
FPL1000
Parameters:
<TriggerLevel>
Example:
Manual operation:
TRIGger[:SEQuence]:LEVel:IQPower <TriggerLevel>
This command defines the magnitude the I/Q data must exceed to cause a trigger
event.
Note that any RF attenuation or preamplification is considered when the trigger level is
analyzed. If defined, a reference level offset is also considered.
Parameters:
<TriggerLevel>
Example:
Manual operation:
TRIGger[:SEQuence]:SLOPe <Type>
For all trigger sources except time you can define whether triggering occurs when the
signal rises to the trigger level or falls down to it.
Parameters:
<Type>
Example:
Manual operation:
TRIGger[:SEQuence]:SOURce <Source>
This command selects the trigger source.
For details on trigger sources see
Note on external triggers:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
For details on available trigger levels and trigger bandwidths see
the data sheet.
*RST:
-20 dBm
Default unit: DBM
TRIG:LEV:IFP -30DBM
See
"Trigger Level"
on page 346
Range:
-130 dBm to 30 dBm
*RST:
-20 dBm
Default unit: DBM
TRIG:LEV:IQP -30DBM
See
"Trigger Level"
on page 346
POSitive | NEGative
POSitive
Triggers when the signal rises to the trigger level (rising edge).
NEGative
Triggers when the signal drops to the trigger level (falling edge).
*RST:
POSitive
TRIG:SLOP NEG
See
"Slope"
on page 347
"Trigger Source"
Remote commands
on page 344.
786
786