Rohde & Schwarz FPL1000 Manuel D'utilisation page 648

®
R&S FPL1000
If you have defined an absolute limit as well as a relative limit, the R&S FPL1000 uses
the lower value for the limit check.
Suffix:
<n>
<li>
<ch>
Parameters:
<LowerLimit>
<UpperLimit>
Manual operation:
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>:ABSolute:STATe <State>[,
This command turns the absolute limit check for the alternate channels on and off.
You have to activate the general ACLR limit check before using this command with
CALCulate<n>:LIMit<li>:ACPower[:STATe].
Suffix:
<n>
<li>
<ch>
Parameters:
<State>
<State>
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
irrelevant
irrelevant
1..n
Alternate channel number
The limit of the lower adjacent channel.
Range:
*RST:
Default unit: dBm
The limit of the upper adjacent channel.
Range:
*RST:
Default unit: dBm
See "Limit Check"
<State>]
irrelevant
irrelevant
1..n
Alternate channel number
ON | OFF | 1 | 0
Absolute limit check for lower alternate channel
*RST:
ON | OFF | 1 | 0
Absolute limit check for upper alternate channel
*RST:
See "Limit Check"
Configuring and performing measurements
-200 dBm to 200 dBm
-200 dBm
-200 dBm to 200 dBm
-200 dBm
on page 146
0
0
on page 146
Remote commands
648 648