Rohde & Schwarz FPL1000 Manuel D'utilisation page 743

Masquer les pouces Voir aussi pour FPL1000:

Les langues disponibles

Instrument setup and querying of the result list at the end of the measurement:

With this method, the control computer may be used for other activities while the

measurement is being performed. However, more time is needed for synchroniza-

tion via service request.

Performing pulse power measurements

The following commands control pulse power measurements.

CALCulate<n>:MARKer<m>:FUNCtion:MSUMmary

[SENSe:]MPOWer:FTYPe

[SENSe:]MPOWer:RESult[:LIST]?

[SENSe:]MPOWer[:SEQuence]

[SENSe:]MPOWer:RESult:MIN?

CALCulate<n>:MARKer<m>:FUNCtion:MSUMmary <TimeOffset>, <MeasTime>,

This command configures power measurements on pulses in the time domain.

To evaluate the pulse power, the R&S FPL1000 uses the data captured during a previ-

ous measurement. The data recorded during the set measurement time is combined to

a measured value for each pulse according to the detector specified and the indicated

number of results is output as a list.

To get a valid result, you have to perform a complete measurement with synchroniza-

tion to the end of the measurement before reading out the result. This is only possible

for single sweep mode.