Rohde & Schwarz FPL1000 Manuel D'utilisation page 740

®
R&S FPL1000
<RBW>
<VBW>
<MeasTime>
<TriggerLevel>
Example:
[SENSe:]LIST:POWer:SET <State>, <State>, <State>, <TriggerSource>,
This command defines global List Evaluation parameters.
These parameters are valid for every frequency you want to measure.
The state of the first three parameters (<PeakPower>, <RMSPower> and <AVG-
Power>) define the number of results for each frequency in the list.
Note that you have to set the trigger level after sending this command.
Parameters:
<State>
<State>
<State>
<TriggerSource>
<TriggerSlope>
<TriggerOffset>
Manuel d'utilisation 1179.5860.09 - 12
Defines the resolution bandwidth for a list entry.
Defines the measurement time for a list entry.
Defines the measurement time for a list entry.
Range:
Default unit: s
Reserved for future use; currently: must be 0.
See Chapter 10.6.15.2, "Example: performing list
on page 735.
<TriggerSlope>, <TriggerOffset>, <GateLength>
ON | OFF | 0 | 1
Turns peak power evaluation on and off.
*RST:
ON | OFF | 0 | 1
Turns RMS power evaluation on and off.
*RST:
ON | OFF | 0 | 1
Turns average power evaluation on and off.
*RST:
IMMediate | LINE | EXTernal | VIDeo | RFPower | IFPower |
RFPower | EXT2 | EXT3 | EXT4 | LXI | EXTernal | IMMediate |
IFPower | RFPower | VIDeo
Selects a trigger source.
POSitive | NEGative
Selects the trigger slop.
Defines the trigger delay.
Range:
*RST:
Default unit: s
Configuring and performing measurements
1 µs to 16000 s
1
0
0
negative measurement time to 30 s
0
Remote commands
evaluation",
740 740