Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
[SENSe:]CORRection:TRANsducer:SCALing <ScalingType>
This command selects the frequency scaling of the transducer factor.
Parameters:
<ScalingType>
Manual operation:
[SENSe:]CORRection:TRANsducer:SELect <Name>
This command selects a transducer factor.
Parameters:
<Name>
Example:
Manual operation:
[SENSe:]CORRection:TRANsducer[:STATe] <State>
This command turns the selected transducer factor on or off.
Before you can use the command, you have to select a transducer.
Parameters:
<State>
Manual operation:
[SENSe:]CORRection:TRANsducer:UNIT <Unit>
This command selects the unit of the transducer factor.
Before you can use the command, you have to select and turn on a transducer.
Parameters:
<Unit>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
LINear | LOGarithmic
*RST:
LINear
See
"X-Axis Scaling"
on page 542
String containing the name of the transducer factor.
If the name does not exist yet, the R&S FPL1000 creates a
transducer factor by that name.
CORR:TRAN:SEL 'FACTOR1'
See
"Activating / Deactivating"
See
"Create New Line"
See
"Name"
on page 542
ON | OFF | 1 | 0
*RST:
0
See
"Activating / Deactivating"
string as defined in table below
*RST:
DB
CORR:TRAN:UNIT 'DBUV'
See
"Unit"
on page 542
Remote commands
Configuring the R&S FPL1000
on page 540
on page 540
on page 540
971
971
Publicité
