Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<Points>
Example:
Manual operation:
[SENSe:]LIST:RANGe<ri>:RLEVel <RefLevel>
This command defines the reference level for a spurious emission measurement
range.
Suffix:
<ri>
Parameters:
<RefLevel>
Example:
Manual operation:
[SENSe:]LIST:RANGe<ri>:SWEep:TIME <SweepTime>
This command defines the sweep time for a spurious emission measurement range.
Suffix:
<ri>
Parameters:
<SweepTime>
Example:
Manual operation:
[SENSe:]LIST:RANGe<ri>:SWEep:TIME:AUTO <State>
This command turns automatic selection of the sweep time for a spurious emission
measurement range on and off.
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
For more information on sweep points see
"How much data is measured: sweep points and sweep
on page 329.
*RST:
1001
LIST:RANG2:POIN 1000
See
"Sweep Points"
on page 212
1..n
Selects the measurement range.
Reference level.
Refer to the data sheet for the reference level range.
*RST:
0 dBm
Default unit: dBm
LIST:RANG2:RLEV 1DBM
See
"Reference Level"
1..n
Selects the measurement range.
Sweep time.
The range depends on the ratios of the span to the RBW and
the RBW to the VBW. Refer to the data sheet for more informa-
tion.
LIST:RANG2:SWE:TIME 2MS
See
" Sweep Time "
on page 211
Remote commands
Chapter 6.6.1.8,
on page 212
count",
694
694
Publicité
