Rohde & Schwarz FPL1000 Manuel D'utilisation page 788

®
R&S FPL1000
10.8.4.2 Configuring gated measurements
[SENSe:]SWEep:EGATe
[SENSe:]SWEep:EGATe:HOLDoff
[SENSe:]SWEep:EGATe:LENGth
[SENSe:]SWEep:EGATe:POLarity
[SENSe:]SWEep:EGATe:SOURce
[SENSe:]SWEep:EGATe:TYPE
[SENSe:]SWEep:EGATe <State>
This command turns gated measurements on and off.
The measurement ends when a particular number of measurement points has been
recorded.
(See
Performing gated measurements turns the squelch off.
Parameters:
<State>
Example:
Manual operation:
[SENSe:]SWEep:EGATe:HOLDoff <DelayTime>
This command defines the delay time between the gate signal and the continuation of
the measurement.
Note: If you perform gated measurements in combination with the IF Power trigger, the
R&S FPL1000 ignores the holding time for frequency sweep, FFT sweep, zero span
and I/Q mode measurements.
Manuel d'utilisation 1179.5860.09 - 12
.......................................................................................................... 782
[SENSe:]SWEep[:WINDow<n>]:POINts
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
SWE:EGAT ON
Switches on the gate mode.
SWE:EGAT:TYPE EDGE
Switches on the edge-triggered mode.
SWE:EGAT:HOLD 100US
Sets the gate delay to 100 µs.
SWE:EGAT:LEN 500US
Sets the gate opening time to 500 µs.
INIT;*WAI
Starts a sweep and waits for its end.
See "Gated Trigger"
See "Gated Trigger"
Setting basic spectrum RF measurement parameters
........................................................................................... 782
............................................................................................ 783
........................................................................................... 783
.......................................................................................... 783
............................................................................................... 784
on page 769).
on page 224
on page 350
Remote commands
788 788