Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<Volume>
Example:
Manual operation:
10.8.6
Zooming into the display
10.8.6.1
Using the single zoom
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:AREA
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM[:STATe]
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:AREA <x1>,<y1>,<x2>,<y2>
This command defines the zoom area.
To define a zoom area, you first have to turn the zoom on.
1 = origin of coordinate system (x1 = 0, y1 = 0)
2 = end point of system (x2 = 100, y2= 100)
3 = zoom area (e.g. x1 = 60, y1 = 30, x2 = 80, y2 = 75)
Suffix:
<n>
<w>
Parameters:
<x1>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Percentage of the maximum possible volume.
Range:
0 to 1
*RST:
0.5
SYST:SPE:VOL 0
Switches the loudspeaker to mute.
See
"Data Output"
on page 308
See
"Audio Output Volume"
Window
subwindow
Not supported by all applications
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
Remote commands
on page 387
......................................................... 808
..................................................... 809
814
814
Publicité
