®
R&S
FPL1000
<y2>
Manual operation:
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>[:STATe] <State>
This command turns the multiple zoom on and off.
Suffix:
<n>
<w>
<zn>
Parameters:
<State>
Manual operation:
10.8.7
Configuring the trace display and retrieving trace data
The commands required to work with traces are described here.
Commands required to export traces (and other result data) are described in
ter 10.9.5, "Storing measurement
●
Configuring standard
●
Configuring spectrograms
●
Using trace mathematics
●
Retrieving trace results
●
Formats for returned values: ASCII format and binary format
●
Importing and exporting traces
●
Programming example: configuring a spectrogram
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
See
"Multi-Zoom"
on page 451
Window
subwindow
Not supported by all applications
Selects the zoom window.
If you turn off one of the zoom windows, all subsequent zoom
windows move up one position.
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
See
"Multi-Zoom"
on page 451
See
"Restore Original Display"
results",
on page 943.
traces.......................................................................................... 812
............................................................................................. 818
............................................................................................... 826
.................................................................................................. 828
..................................................................................... 832
Remote commands
on page 452
................................. 831
.................................................. 834
Chap-
817
817