Rohde & Schwarz FPL1000 Manuel D'utilisation page 718

®
R&S FPL1000
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<StandardDeviation> Standard deviation of the signal during the measurement time.
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation:RESult?
This command queries the standard deviation of the time domain power.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<StandardDeviation> Standard deviation of the signal during the measurement time.
Usage:
10.6.10.4 Programming example: time domain power
This programming example demonstrates the measurement example described in
Chapter 6.2.10.6, "Measurement
//-------------Configuring the Measurement-----------------------
*RST
//Resets the instrument
INIT:CONT OFF
//Turns on single sweep mode.
FREQ:CENT 1.8GHz
//Sets the center frequency to 1.8 GHz.
BAND:RES 100kHz
//Sets the bandwidth to 100 kHz.
SWE:TIME 10ms
Manuel d'utilisation 1179.5860.09 - 12
INITiate<n>:CONTinuous
Window
Marker
Query only
INITiate<n>:CONTinuous
Window
Marker
Query only
Configuring and performing measurements
on page 620.
on page 620.
example", on page 236 in a remote environment.
Remote commands
718 718