Rohde & Schwarz FPL1000 Manuel D'utilisation page 591

®
R&S FPL1000
If you have entered an invalid IP address or subnet mask, the message "out of
range" is displayed in the status line. If the settings are correct, the configuration is
saved, and you are prompted to restart the instrument.
8. Confirm the displayed message ("Yes" button) to restart the instrument.
Using a DNS server to determine the IP address
If a DNS server is configured on the R&S FPL1000, the server can determine the cur-
rent IP address for the connection using the permanent computer name.
1. Obtain the name of your DNS domain and the IP addresses of the DNS and WINS
servers on your network (see
name",
2. Press the [Setup] key and then the "Network + Remote" softkey.
3. In the "Network" tab, select the "Open Dialog 'Network Connections'" button.
4. Double-tap the "Ethernet" entry.
5. In the "Ethernet Status" dialog box, select the "Properties" button.
The items used by the Ethernet connection are displayed.
6. Tap the entry named "Internet Protocol Version 4 (TCP/IPv4)" to highlight it.
7. Select the "Properties" button.
8. On the "General" tab, select "Use the following DNS server addresses" and enter
your own DNS addresses.
For more information refer to the Windows operating system Help.
Manuel d'utilisation 1179.5860.09 - 12
Chapter 9.5.1.3, "How to change the instrument
on page 586).
Network operation and remote control
How to set up a network and remote control
591 591