Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
CALCulate<n>:LIMit<li>:LOWer[:DATA] <LimitLinePoints>
This command defines the vertical definition points of a lower limit line.
Suffix:
<n>
<li>
Parameters:
<LimitLinePoints>
Manual operation:
CALCulate<n>:LIMit<li>:LOWer:MARGin <Margin>
This command defines an area around a lower limit line where limit check violations
are still tolerated.
Suffix:
<n>
<li>
Parameters:
<Margin>
Manual operation:
CALCulate<n>:LIMit<li>:LOWer:MODE <Mode>
This command selects the vertical limit line scaling.
Suffix:
<n>
<li>
Parameters:
<Mode>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
irrelevant
Limit line
Variable number of level values.
Note that the number of vertical values has to be the same as
the number of horizontal values set with
LIMit<li>:CONTrol[:DATA]. If not, the R&S FPL1000 either
adds missing values or ignores surplus values.
CALCulate<n>:LIMit<li>:UNIT
The unit depends on
on page 908.
*RST:
Limit line state is OFF
Default unit: DBM
See
"Data Points"
on page 441
irrelevant
Limit line
numeric value
*RST:
0
Default unit: dB
See
"Margin"
on page 441
Window
Limit line
ABSolute
Limit line is defined by absolute physical values.
The unit is variable.
Remote commands
CALCulate<n>:
911
911
Publicité
