Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Suffix:
<ch>
Parameters:
<Spacing>
Manual operation:
[SENSe:]POWer:ACHannel:SPACing:CHANnel<ch> <Spacing>
This command defines the distance between transmission channels.
If you set the channel spacing for a transmission channel, the R&S FPL1000 sets the
spacing of the lower transmission channels to the same value, but not the other way
round. The command works hierarchically: to set a distance between the 2nd and 3rd
and 3rd and 4th channel, you have to set the spacing between the 2nd and 3rd chan-
nel first.
Suffix:
<ch>
Parameters:
<Spacing>
Manual operation:
[SENSe:]POWer:ACHannel:TXCHannel:COUNt <Number>
This command defines the number of transmission channels.
The command works for measurements in the frequency domain.
Parameters:
<Number>
Manual operation:
10.6.4.3
Defining weighting filters
The following commands define weighting filters for ACLR measurements.
[SENSe:]POWer:ACHannel:FILTer:ALPHa:ACHannel
[SENSe:]POWer:ACHannel:FILTer:ALPHa[:ALL]
[SENSe:]POWer:ACHannel:FILTer:ALPHa:ALTernate<ch>
[SENSe:]POWer:ACHannel:FILTer:ALPHa:CHANnel<ch>
[SENSe:]POWer:ACHannel:FILTer[:STATe]:ACHannel
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
1..n
Alternate channel number
Range:
100 Hz to 2000 MHz
*RST:
40 kHz (ALT1), 60 kHz (ALT2), 80 kHz (ALT3), ...
Default unit: Hz
See
"Channel Spacings"
1..n
Tx channel number
Range:
14 kHz to 2000 MHz
*RST:
20 kHz
Default unit: Hz
See
"Channel Spacings"
Range:
1 to 18
*RST:
1
See
"Number of channels: Tx, Adj"
.................................................................... 636
Remote commands
on page 145
on page 145
on page 142
............................................................ 636
.................................................... 636
...................................................... 636
........................................................... 637
641
641
Publicité
