Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
[SENSe:]BWIDth[:RESolution]:TYPE <FilterType>
[SENSe:]BANDwidth[:RESolution]:TYPE <FilterType>
This command selects the resolution filter type.
When you change the filter type, the command selects the next larger filter bandwidth if
the same bandwidth is unavailable for that filter.
The EMI-specific filter types are available if the EMI (R&S FPL1-K54) measurement
option is installed, even if EMI measurement is not active. For details see
bandwidth and filter types"
Parameters:
<FilterType>
Example:
Example:
Manual operation:
[SENSe:]BWIDth:VIDeo <Bandwidth>
[SENSe:]BANDwidth:VIDeo <Bandwidth>
This command defines the video bandwidth.
The command decouples the video bandwidth from the resolution bandwidths.
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
BAND:RAT 0.1
See
"Span/RBW"
on page 333
on page 259.
CFILter
Channel filters
NORMal
Gaussian filters
P5
5-pole filters
The 5-pole filter is not available for FFT sweeps.
RRC
RRC filters
CISPr | PULSe
CISPR (6 dB) - requires EMI (R&S FPL1-K54) option
Return value for query is always PULS.
MIL
MIL Std (6 dB) - requires EMI (R&S FPL1-K54) option
*RST:
NORMal
BAND:TYPE NORM
See
Chapter 10.6.17, "Programming example: performing a
basic frequency
sweep",
See
"Filter Type"
on page 273
See
"Res BW CISPR"
See
"Res BW MIL"
on page 275
Remote commands
on page 740.
on page 275
"Resolution
771
771
Publicité
