Rohde & Schwarz FPL1000 Manuel D'utilisation page 595

®
R&S FPL1000
9.5.1.5 How to change the GPIB instrument address
In order to operate the instrument via remote control, it must be addressed using the
GPIB address. The remote control address is factory-set to 20, but it can be changed if
it does not fit in the network environment. For remote control, addresses 0 through 30
are allowed. The GPIB address is maintained after a reset of the instrument settings.
Setting the GPIB address
1. On the R&S FPL1000, press the [SETUP] key.
2. Press the "Network + Remote" softkey.
3. In the "Network + Remote" dialog box, select the "GPIB" tab.
4. In the "GPIB Address" field, enter a value between 0 and 30.
Remote command:
SYST:COMM:GPIB:ADDR 18
9.5.2 How to operate the instrument without a network
To operate the instrument without a network connection either temporarily or perma-
nently, no special measures are necessary. Windows automatically detects the inter-
ruption of the network connection and does not set up the connection when the instru-
ment is switched on.
If you are not prompted to enter the user name and password, proceed as described in
Chapter 9.5.3.3, "How to configure the automatic login
9.5.3 How to log on to the network
Windows requires that users identify themselves by entering a user name and pass-
word in a login window. You can set up two types of user accounts, either an adminis-
trator account with unrestricted access to the computer/domain or a standard user
account with limited access. The instrument provides an auto-login function for the
administrator account, i.e. login with unrestricted access is carried out automatically in
the background. By default, the user name for the administrator account is "Instru-
ment", and the user name for the standard user account is "NormalUser". In both
cases the initial password is "894129". You can change the password in Windows for
any user at any time. Some administrative tasks require administrator rights (e.g. firm-
ware updates or the configuration of a LAN network). If so, it is mentioned in the func-
tion descriptions.
At the same time you log on to the operating system, you are automatically logged on
to the network. As a prerequisite, the user name and the password must be identical
on the instrument and on the network.
Manuel d'utilisation 1179.5860.09 - 12
Network operation and remote control
How to set up a network and remote control
mechanism", on page 591.
595 595