Rohde & Schwarz FPL1000 Manuel D'utilisation page 669

®
R&S FPL1000
Example:
Manual operation:
[SENSe:]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:STARt:FUNCtion
Suffix:
<sb>
<ri>
<li>
Parameters:
<Function>
Example:
Manual operation:
[SENSe:]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:STOP <Level>
This command defines a relative limit for a SEM range.
Unlike manual operation, you can define a relative limit anytime and regardless of the
limit check mode.
Suffix:
<sb>
Manuel d'utilisation 1179.5860.09 - 12
SENSe:ESPectrum:RANGe:LIMit:RELative:STARt:
ABSolute -10
For a detailed example see
measurement",
See "Rel Limit Start / Stop <n>"
<Function>
1 to 3
1..n
Selects the SEM range.
1..n
Power class for which the limit is defined.
OFF | MAX
Defines the function to be used to determine the relative limit
line start value
MAX
The maximum of the relative and the absolute level is used as
the limit start value. Use the
RANGe<ri>:LIMit<li>:RELative:STARt
]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:
STARt:ABS
OFF
No function is used, the relative limit line is defined by a fixed
relative start value. Use the
RANGe<ri>:LIMit<li>:RELative:STARtcommand to
define this value.
*RST:
SENSe:ESPectrum:RANGe:LIMit:RELative:STARt:
FUNCtion MAX
For a detailed example see
measurement",
See "Rel Limit Start / Stop <n>"
1 to 3
Configuring and performing measurements
Chapter 10.6.7.10, "Example: SEM
on page 678.
on page 183
[SENSe:]ESPectrum<sb>:
commands to define these values.
[SENSe:]ESPectrum<sb>:
OFF
Chapter 10.6.7.10, "Example: SEM
on page 678.
on page 183
Remote commands
[SENSe:
and
669 669