Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
CALCulate<n>:MARKer<m>:TRACe <Trace>
This command selects the trace the marker is positioned on.
Note that the corresponding trace must have a trace mode other than "Blank".
If necessary, the command activates the marker first.
Suffix:
<n>
<m>
Parameters:
<Trace>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:X <Position>
This command moves a marker to a specific coordinate on the x-axis.
If necessary, the command activates the marker.
If the marker has been used as a delta marker, the command turns it into a normal
marker.
Suffix:
<n>
<m>
Parameters:
<Position>
Example:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
ON | 1
Switches the function on
CALC:MARK3 ON
Switches on marker 3.
See
"Marker State"
on page 269
See
"Marker Type"
on page 269
See
"Select Marker"
on page 271
Window
Marker
1 to 6
Trace number the marker is assigned to.
//Assign marker to trace 1
CALC:MARK3:TRAC 2
See
"Assigning the Marker to a Trace"
Window
Marker
Numeric value that defines the marker position on the x-axis.
The unit depends on the result display.
Range:
The range depends on the current x-axis range.
Default unit: Hz
CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
Remote commands
on page 270
850
850
Publicité
