Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
INPut<ip>:ATTenuation:PROTection:RESet
This command resets the attenuator and reconnects the RF input with the input mixer
for the R&S FPL1000 after an overload condition occurred and the protection mecha-
nism intervened. The error status bit (bit 3 in the STAT:QUES:POW status register) and
the INPUT OVLD message in the status bar are cleared.
(See
ter 9.2.2.12, "STATus:QUEStionable:POWer
The command works only if the overload condition has been eliminated first.
For details on the protection mechanism see
Suffix:
<ip>
Example:
INPut<ip>:FILTer:SAW <State>
Determines which IF path the R&S FPL1000 hardware uses.
Suffix:
<ip>
Parameters:
<State>
Example:
Manual operation:
INPut<ip>:FILTer:YIG[:STATe] <State>
Enables or disables the YIG filter.
Suffix:
<ip>
Parameters:
<State>
Example:
Manuel d'utilisation 1179.5860.09 - 12
STATus:QUEStionable:POWer[:EVENt]?
1 | 2
irrelevant
INP:ATT:PROT:RES
1 | 2
irrelevant
AUTO | OFF
AUTO
The R&S FPL1000 determines which IF path to use automati-
cally, depending on the used analysis bandwidth.
OFF
The wide IF path is always used.
*RST:
INP:FILT:SAW AUTO
See
"SAW filter"
1 | 2
irrelevant
ON | OFF | 0 | 1
INP:FILT:YIG OFF
Deactivates the YIG-preselector.
Setting basic spectrum RF measurement parameters
on page 1017 and
register",
on page 567).
"RF Input Protection"
I/Q Analyzer: AUTO; VSA: OFF
on page 284
Remote commands
Chap-
on page 283.
791
791
Publicité
