Rohde & Schwarz FPL1000 Manuel D'utilisation page 630

®
R&S FPL1000
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>[:STATe] <State>
This command turns a power measurement on and off.
Suffix:
<n>
<m>
<sb>
Parameters:
<State>
Manual operation:
[SENSe:]POWer:ACHannel:PRESet <Measurement>
This command determines the ideal span, bandwidths and detector for the current
power measurement.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Parameters:
<Measurement>
Manuel d'utilisation 1179.5860.09 - 12
OBANdwidth | OBWidth
Occupied bandwidth measurement.
The R&S FPL1000 performs the measurement on the trace that
marker 1 is positioned on.
CN
Carrier-to-noise ratio measurement.
CN0
Carrier-to-noise ratio measurement referenced to 1 Hz band-
width
See "C/N"
See "C/N0"
irrelevant
irrelevant
irrelevant
ON | OFF | 1 | 0
ON | 1
The power measurement selected with
MARKer<m>:FUNCtion:POWer<sb>:SELect
OFF | 0
A standard frequency sweep is activated.
*RST:
See "C/N"
See "C/N0"
INITiate<n>:CONTinuous
ACPower | MCACpower
ACLR measurement
CPOWer
channel power measurement
Configuring and performing measurements
on page 157
on page 157
0
on page 157
on page 157
on page 620.
Remote commands
CALCulate<n>:
is activated.
630 630