Rohde & Schwarz FPL1000 Manuel D'utilisation page 575

Masquer les pouces Voir aussi pour FPL1000:

Les langues disponibles

Reset values of the status reporting system

The following table contains the different commands and events causing the status

reporting system to be reset. None of the commands, except *RST and

SYSTem:PRESet, influence the functional instrument settings. In particular, DCL does

not change the instrument settings.

Table 9-15: Resetting the status reporting system

Clear STB, ESR

Clear SRE, ESE

Clear EVENt parts of the regis-

Clear ENABle parts of all

OPERation and QUEStionable

Fill ENABle parts of all other

registers with "1".

Fill PTRansition parts with "1";

Clear NTRansition parts

Clear error queue

Clear output buffer

Clear command processing

and input buffer

1) The first command in a command line that immediately follows a <PROGRAM MESSAGE TERMINA-

TOR> clears the output buffer.

9.3 GPIB languages

The R&S FPL1000 analyzer family supports a subset of the GPIB commands used by

other devices. Thus it can emulate other devices in order to use existing remote control

Manuel d'utilisation 1179.5860.09 - 12

This bit is always 0.

Switching on supply

Power-On-Status-

Network operation and remote control

GPIB languages