Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Manual operation:
10.8.8.2
General marker settings
The following commands control general marker functionality.
Remote commands exclusive to general marker functionality
DISPlay[:WINDow<n>]:MTABle
DISPlay[:WINDow<n>]:MINFo[:STATe]
CALCulate<n>:MARKer<m>:X:SSIZe
DISPlay[:WINDow<n>]:MTABle <DisplayMode>
This command turns the marker table on and off.
Suffix:
<n>
Parameters:
<DisplayMode>
Example:
Manual operation:
DISPlay[:WINDow<n>]:MINFo[:STATe] <State>
This command turns the marker information in all diagrams on and off.
Suffix:
<n>
Parameters:
<State>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
See
"Marker Table"
on page 124
See
"Marker Peak List"
See
"Marker 1/Marker 2/Marker 3/Marker 4"
See
"Marker 1/Marker 2/Marker 3"
See
"Marker Position X-value"
............................................................................................... 845
................................................................................... 845
...................................................................................... 846
irrelevant
ON | 1
Turns on the marker table.
OFF | 0
Turns off the marker table.
AUTO
Turns on the marker table if 3 or more markers are active.
*RST:
AUTO
DISP:MTAB ON
Activates the marker table.
See
"Marker Table Display"
irrelevant
ON | 1
Displays the marker information in the diagrams.
OFF | 0
Hides the marker information in the diagrams.
*RST:
1
Remote commands
on page 124
on page 250
on page 254
on page 269
on page 361
851
851
Publicité
