Rohde & Schwarz FPL1000 Manuel D'utilisation page 579

®
Network operation and remote control
R&S FPL1000
Network and remote control settings
IP Address
Defines the IP address. The TCP/IP protocol is preinstalled with the IP address
10.0.0.10. If the DHCP server is available ("DHCP On"), the setting is read-only.
The IP address consists of four number blocks separated by dots. Each block contains
3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address).
Subnet Mask
Defines the subnet mask. The TCP/IP protocol is preinstalled with the subnet mask
255.255.255.0. If the DHCP server is available ("DHCP On"), this setting is read-only.
The subnet mask consists of four number blocks separated by dots. Each block con-
tains 3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address).
DHCP
Switches between DHCP server available (On) or not available (Off). If a DHCP server
is available in the network, the IP address and subnet mask of the instrument are
obtained automatically from the DHCP server.
Network Configuration
Opens the standard Windows "Network Configuration" dialog box for further configura-
tion.
9.4.2 Remote settings
Access: [Setup] > "Network + Remote" > "Remote" tab
GPIB-specific settings are only available if option R&S FPL1-B10 is installed on the
R&S FPL1000.
Manuel d'utilisation 1179.5860.09 - 12 579 579