Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
10.6.14.4
Configuring EMI limit lines
The commands required to define limit lines for EMI measurements are described in
Chapter 10.8.9, "Configuring display
10.6.14.5
Controlling LISN
The commands required to control a LISN are described here.
This feature requires the optional additional interfaces (R&S FPL1-B5).
INPut<ip>:LISN:FILTer:HPASs[:STATe]
INPut<ip>:LISN:PHASe
INPut<ip>:LISN[:TYPE]
INPut<ip>:LISN:FILTer:HPASs[:STATe] <State>
This command turns the 150 kHz highpass filter for the ENV216 network on and off.
Suffix:
<ip>
Parameters:
<State>
Example:
Manual operation:
INPut<ip>:LISN:PHASe <Phase>
This command selects one LISN phase to be measured.
Suffix:
<ip>
Parameters:
<Phase>
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
lines",
on page 898.
......................................................................................... 726
............................................................................................................ 726
............................................................................................................ 727
1 | 2
irrelevant
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST:
0
//Turn on high pass filter
INP:LISN:TYPE ENV216
INP:LISN:FILT:HPAS ON
See
"150 kHz Highpass"
1 | 2
irrelevant
L1
L2
Available for networks with four phases (R&S ESH2Z5,
R&S ENV4200 and R&S ENV432)
Remote commands
on page 276
732
732
Publicité
