Rohde & Schwarz FPL1000 Manuel D'utilisation page 645

®
R&S FPL1000
The results of the power limit checks are also indicated in the STAT:QUES:ACPL sta-
tus registry (see
on page 563).
CALCulate<n>:LIMit<li>:ACPower:ACHannel:ABSolute
CALCulate<n>:LIMit<li>:ACPower:ACHannel:ABSolute:STATe
CALCulate<n>:LIMit<li>:ACPower:ACHannel[:RELative]
CALCulate<n>:LIMit<li>:ACPower:ACHannel:RESult?
CALCulate<n>:LIMit<li>:ACPower:ACHannel[:RELative]:STATe
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>:ABSolute
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>:ABSolute:STATe
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>[:RELative]
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>:RESult?
CALCulate<n>:LIMit<li>:ACPower:ALTernate<ch>[:RELative]:STATe
CALCulate<n>:LIMit<li>:ACPower[:STATe]
CALCulate<n>:LIMit<li>:ACPower:ACHannel:ABSolute <LowerLimit>[,
This command defines the absolute limit of the adjacent channels.
If you have defined an absolute limit as well as a relative limit, the R&S FPL1000 uses
the lower value for the limit check.
Suffix:
<n>
<li>
Parameters:
<LowerLimit>
<UpperLimit>
Manual operation:
CALCulate<n>:LIMit<li>:ACPower:ACHannel:ABSolute:STATe <State>[, <State>]
This command turns the absolute limit check for the adjacent channels on and off.
You have to activate the general ACLR limit check before using this command with
CALCulate<n>:LIMit<li>:ACPower[:STATe].
Suffix:
<n>
<li>
Manuel d'utilisation 1179.5860.09 - 12
Chapter 9.2.2.6, "STATus:QUEStionable:ACPLimit
<UpperLimit>]
irrelevant
irrelevant
The limit of the lower adjacent channel.
Range:
*RST:
Default unit: dBm
The limit of the upper adjacent channel.
Range:
*RST:
Default unit: dBm
See "Limit Check"
irrelevant
irrelevant
Configuring and performing measurements
.......................................................... 639
.............................................. 639
........................................................ 640
............................................................ 640
.................................................. 641
................................................ 643
................................................... 643
............................................................................. 644
-200 dBm to 200 dBm
-200 dBm
-200 dBm to 200 dBm
-200 dBm
on page 146
Remote commands
register",
............................................ 641
....................................... 642
..................................... 644
645 645