Rohde & Schwarz FPL1000 Manuel D'utilisation page 707

®
R&S FPL1000
CALCulate<n>:STATistics:SCALe:Y:UPPer <Magnitude>
This command defines the upper vertical limit of the diagram.
Suffix:
<n>
Parameters:
<Magnitude>
Example:
Manual operation:
10.6.9.5 Performing a statistical measurement
The following commands are required to perform a statistical measurement:
INITiate<n>[:IMMediate]
surements",
10.6.9.6 Retrieving results
The following commands are required to retrieve the measurement results.
Useful commands for retrieving results described elsewhere:
●
CALCulate<n>:MARKer<m>:X
Remote commands exclusive to statistical results
CALCulate<n>:STATistics:CCDF:X<t>?
CALCulate<n>:STATistics:RESult<res>?
CALCulate<n>:STATistics:CCDF:X<t>? <Probability>
This command queries the results of the CCDF.
Suffix:
<n>
<t>
Query parameters:
<Probability>
Manuel d'utilisation 1179.5860.09 - 12
Window
The number is a statistical value and therefore dimensionless.
Range:
*RST:
CALC:STAT:SCAL:Y:UPP 0.01
See "Y-Max/ Y-Min"
on page 620, see
on page 618
Window
Trace
P0_01
Level value for 0.01 % probability
P0_1
Level value for 0.1 % probability
P1
P1: Level value for 1 % probability
Configuring and performing measurements
1E-5 to 1.0
1.0
on page 227
Chapter 10.6.1, "Performing mea-
on page 844
.................................................................................. 701
................................................................................ 702
Remote commands
707 707