Rohde & Schwarz FPL1000 Manuel D'utilisation page 605

®
R&S FPL1000
●
●
9.5.7.3 How to start and close the remote desktop
To set up a connection to the R&S FPL1000
1. In the "Remote Desktop Connection" dialog box (see
figure the
2. In the "Computer" field, enter the IP address of the R&S FPL1000.
In the "User name" field, enter instrument to log in as an administrator, or Normal
User to log in as a standard user.
In the "Password" field, enter 894129.
3. To save the connection configuration for later use:
a) Select the "Save As" button.
b) Enter the name for the connection information (*.RDP).
4. To load an existing connection configuration:
a) Select the "Open" button.
b) Select the *.RDP file.
5. Select the "Connect" button.
The connection is set up.
6. If the "Disk drives" option is activated on the "Local Resources" tab, a warning is
displayed indicating that the drives are enabled for access from the R&S FPL1000.
Select "OK" to confirm the warning.
7. After a few moments, the R&S FPL1000 screen is displayed.
If a dark screen appears or a dark square appears in the upper left-hand corner of
the screen, you must restart the R&S FPL1000 in order to see the modified screen
resolution.
Manuel d'utilisation 1179.5860.09 - 12
If activated, a bar showing the network address of the R&S FPL1000 will
appear at the top edge of the screen. You can use this bar to reduce, minimize
or close the window.
If deactivated, the only way you can return to the controller desktop from the
R&S FPL1000 screen in full screen mode is to select "Disconnect" from the
"Start" menu.
controller", on page 596), open the "General" tab.
The "Save As" dialog box is displayed.
The "Open" dialog box is displayed.
Network operation and remote control
How to set up a network and remote control
Press the key combination [ALT] + [F4].
The R&S FPL1000 firmware is shut down, which may take a few
seconds.
On the desktop, double-tap the "Analyzer" icon.
Chapter 9.5.7.2, "How to con-
605 605