Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<SweepTime>
Manual operation:
[SENSe:]ESPectrum<sb>:RANGe<ri>:SWEep:TIME:AUTO <State>
This command turns automatic selection of the sweep time for a SEM range on and
off.
In case of high speed measurements, the sweep time has to be identical for all ranges.
Suffix:
<sb>
<ri>
Parameters:
<State>
Example:
Manual operation:
[SENSe:]ESPectrum<sb>:RANGe<ri>:TRANsducer <Transducer>
This command selects a transducer factor for a SEM range.
Note that
●
the transducer must cover at least the span of the range
●
the x-axis has to be linear
●
the unit has to be dB
Suffix:
<sb>
<ri>
Parameters:
<Transducer>
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
Sweep time.
The range depends on the ratios of the span to the RBW and
the RBW to the VBW. Refer to the data sheet for more informa-
tion.
Default unit: s
See
" Sweep Time "
on page 182
1 to 3
1..n
Selects the measurement range.
ON | OFF | 0 | 1
*RST:
1
ESP:RANG3:SWE:TIME:AUTO OFF
Deactivates the sweep time auto mode for range 3.
See
" Sweep Time Mode "
1 to 3
Sub block in a Multi-SEM measurement
1..n
Selects the measurement range.
String containing the transducer file name, including the path
information.
See
"Transducer Factor"
Remote commands
on page 182
on page 183
674
674
Publicité
