Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]:AUTO <State>
This command couples and decouples the detector to the trace mode.
Suffix:
<n>
<t>
Parameters:
<State>
Example:
Manual operation:
TRACe<n>:COPY <TraceNumber>, <TraceNumber>
This command copies data from one trace to another.
Suffix:
<n>
Parameters:
<TraceNumber>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
POSitive
Positive peak
QPEak
Quasipeak (CISPR filter only)
SAMPle
First value detected per trace point
RMS
RMS value
AVERage
Average
CAVerage
CISPR Average (CISPR filter only)
CRMS
CISPR RMS (CISPR filter only)
*RST:
APEak
DET POS
Sets the detector to "positive peak".
See
"Detector"
on page 405
Window
Trace
ON | OFF | 0 | 1
*RST:
1
DET:AUTO OFF
The selection of the detector is not coupled to the trace mode.
See
"Detector"
on page 405
Window
TRACE1 | TRACE2 | TRACE3 | TRACE4 | TRACE5 | TRACE6
The first parameter is the destination trace, the second parame-
ter is the source.
(Note the 'e' in the parameter is required!)
Remote commands
823
823
Publicité
