Rohde & Schwarz FPL1000 Manuel D'utilisation page 848

®
R&S FPL1000
If necessary, the command activates the delta marker and positions a reference
marker to the peak power.
Suffix:
<n>
<m>
Parameters:
<Position>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:AOFF
This command turns off all markers.
Suffix:
<n>
<m>
Example:
Manual operation:
CALCulate<n>:MARKer<ms>:LINK:TO:DELTa<md> <State>
This command links the normal source marker <ms> to any active delta destination
marker <md>.
If you change the horizontal position of marker <md>, marker <ms> changes its hori-
zontal position to the same value.
Suffix:
<n>
<ms>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Window
Marker
Numeric value that defines the marker position on the x-axis.
The position is relative to the reference marker.
To select an absolute position you have to change the delta
CALCulate<n>:DELTamarker<m>:MODE
marker mode with
on page 840.
A query returns the absolute position of the delta marker.
Range: The value range and unit depend on the measure-
ment and scale of the x-axis.
Default unit: HZ
CALC:DELT:X?
Outputs the absolute x-value of delta marker 1.
See "Marker 1/Marker 2/Marker 3/Marker 4"
See "Marker 1/Marker 2/Marker 3"
See "Marker Position X-value"
Window
Marker
CALC:MARK:AOFF
Switches off all markers.
See "All Markers Off" on page 361
Window
source marker, see Marker
Remote commands
on page 250
on page 254
on page 269
848 848