Rohde & Schwarz FPL1000 Manuel D'utilisation page 890

®
R&S FPL1000
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:STATe <State>
This command turns the n dB Down marker function on and off.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:TIME?
This command queries the position of the n dB down markers on the x-axis when mea-
suring in the time domain.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<TimeX1>
<TimeX2>
Example:
Usage:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
irrelevant
irrelevant
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
CALC:MARK:FUNC:NDBD:STAT ON
Turns the n dB Down marker on.
See "n dB down Marker State"
INITiate<n>:CONTinuous
irrelevant
irrelevant
absolute position in time of the n dB marker to the left of the ref-
erence marker in seconds
absolute position in time of the n dB marker to the right of the
reference marker in seconds
INIT:CONT OFF
Switches to single sweep mode
CALC:MARK:FUNC:NDBD ON
Switches on the n dB down function.
INIT;*WAI
Starts a sweep and waits for the end.
CALC:MARK:FUNC:NDBD:TIME?
Outputs the time values of the temporary markers.
Query only
See "n dB down Value"
Setting basic spectrum RF measurement parameters
on page 381
on page 620.
on page 381
Remote commands
890 890