Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Usage:
*PCB <Address>
Pass control back
Indicates the controller address to which remote control is returned after termination of
the triggered action.
Setting parameters:
<Address>
Usage:
*PRE <Value>
Parallel poll register enable
Sets parallel poll enable register to the indicated value. The query returns the contents
of the parallel poll enable register in decimal form.
Parameters:
<Value>
*PSC <Action>
Power on status clear
Determines whether the contents of the ENABle registers are preserved or reset when
the instrument is switched on. Thus a service request can be triggered when the instru-
ment is switched on, if the status registers ESE and SRE are suitably configured. The
query reads out the contents of the "power-on-status-clear" flag.
Parameters:
<Action>
*RST
Reset
Sets the instrument to a defined default status. The default settings are indicated in the
description of commands.
The command is equivalent to SYSTem:PRESet.
Usage:
Manuel d'utilisation 1179.5860.09 - 12
Query only
Range:
0 to 30
Setting only
Range:
0 to 255
0 | 1
0
The contents of the status registers are preserved.
1
Resets the status registers.
Setting only
Remote commands
Common commands
613
613
Publicité
