Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
//------- Performing the measurement -------------------------
INIT;*WAI
//Performs a measurement and waits for it to end
//---------------Retrieving Results-------------
CALC:MARK1:COUN:FREQ?
//Returns the signal counter value as the precise marker frequency.
10.8.9
Configuring display lines
The commands required to configure display lines in a remote environment are descri-
bed here.
CALCulate<n>:DLINe<dl>
CALCulate<n>:DLINe<dl>:STATe
CALCulate<n>:FLINe<dl>
CALCulate<n>:FLINe<dl>:STATe
CALCulate<n>:PLINe<dl>
CALCulate<n>:PLINe<dl>:STATe
CALCulate<n>:TLINe<dl>
CALCulate<n>:TLINe<dl>:STATe
CALCulate<n>:DLINe<dl> <Position>
This command defines the (horizontal) position of a display line.
Suffix:
<n>
<dl>
Parameters:
<Position>
Example:
Manual operation:
CALCulate<n>:DLINe<dl>:STATe <State>
This command turns a display line on and off
Suffix:
<n>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
........................................................................................................ 898
........................................................................................... 898
........................................................................................................ 899
............................................................................................ 899
........................................................................................................ 900
............................................................................................ 900
........................................................................................................ 900
............................................................................................ 901
Window
1 | 2
The value range is variable.
You can use any unit you want, the R&S FPL1000 then converts
the unit to the currently selected unit. If you omit a unit, the
R&S FPL1000 uses the currently selected unit.
*RST:
(state is OFF)
Default unit: DBM
CALC:DLIN2 -20dBm
Positions the second display line at -20 dBm.
See
"Horizontal Line 1/ Horizontal Line 2"
Window
Remote commands
on page 431
904
904
Publicité
