Rohde & Schwarz FPL1000 Manuel D'utilisation page 719

®
R&S FPL1000
//Sets the sweep time to 640 µs.
FREQ:SPAN 0
//Sets the instrument to zero span.
CALC:MARK:FUNC:SUMM:STAT ON
//Turns on time domain power measurements.
CALC:MARK:FUNC:SUMM:MEAN ON
CALC:MARK:FUNC:SUMM:PPE ON
CALC:MARK:FUNC:SUMM:RMS ON
//Turns the evalution of the mean, peak and RMS time domain power.
CALC:MARK:X:SLIM ON
//Activates limit lines for evaluation.
CALC:MARK:X:SLIM:LEFT 1ms
//Sets the left limit line to 326 µs.
CALC:MARK:X:SLIM:RIGH 6ms
//Sets the right limit line to 538 µs.
//--------------Performing the Measurement------------------------
INIT;*WAI
//Initiates the measurement and waits until the measurement is finished.
//-------------Retrieving the Results--------------------------------
CALC:MARK:FUNC:SUMM:MEAN:RES?
CALC:MARK:FUNC:SUMM:PPE:RES?
CALC:MARK:FUNC:SUMM:RMS:RES?
//Queries the mean, peak and RMS time domain power.
10.6.11 Measuring the harmonic distortion
All remote control commands specific to harmonic distortion measurements are descri-
bed here.
●
Activating the measurement
●
Configuring the measurement
●
Performing the measurement
●
Retrieving results
●
Example: measuring the harmonic distortion
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
......................................................................................... 714
...................................................................................... 714
....................................................................................... 715
............................................................................................................ 716
Remote commands
............................................................. 717
719 719