Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<Shape>
Manual operation:
DISPlay[:WINDow<n>]:SGRam:COLor:UPPer <Percentage>
DISPlay[:WINDow<n>]:SPECtrogram:COLor:UPPer <Percentage>
This command defines the end point of the color map.
Suffix:
<n>
Parameters:
<Percentage>
Example:
Manual operation:
DISPlay[:WINDow<n>]:SGRam:COLor[:STYLe] <ColorScheme>
DISPlay[:WINDow<n>]:SPECtrogram:COLor[:STYLe] <ColorScheme>
This command selects the color scheme.
Parameters:
<ColorScheme>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Shape of the color curve.
Range:
-1 to 1
*RST:
0
See
"Shape"
on page 422
Window
Statistical frequency percentage.
Range:
0 to 66
*RST:
0
Default unit: %
DISP:WIND:SGR:COL:UPP 95
Sets the start of the color map to 95%.
See
"Start / Stop"
on page 422
HOT
Uses a color range from blue to red. Blue colors indicate low lev-
els, red colors indicate high ones.
COLD
Uses a color range from red to blue. Red colors indicate low lev-
els, blue colors indicate high ones.
RADar
Uses a color range from black over green to light turquoise with
shades of green in between.
GRAYscale
Shows the results in shades of gray.
*RST:
HOT
DISP:WIND:SPEC:COL GRAY
Changes the color scheme of the spectrogram to black and
white.
See
"Hot/Cold/Radar/Grayscale"
Remote commands
on page 423
831
831
Publicité
