Rohde & Schwarz FPL1000 Manuel D'utilisation page 717

®
R&S FPL1000
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:RMS:RESult?
This command queries the RMS of the time domain power.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<RMSPower>
Usage:
Manual operation:
Measuring the standard deviation
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation:AVERage:RESult?
This command queries the average standard deviation of the time domain power. The
query is only possible if averaging has been activated previously using
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AVERage
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<StandardDeviation> Standard deviation of the signal during the measurement time.
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation:PHOLd:RESult?
This command queries the maximum standard deviation of the time domain power.
The query is only possible if the peak hold function has been activated previously using
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PHOLd.
Manuel d'utilisation 1179.5860.09 - 12
Query only
INITiate<n>:CONTinuous
Window
Marker
RMS power of the signal during the measurement time.
Query only
See "Results"
INITiate<n>:CONTinuous
Window
Marker
Query only
Configuring and performing measurements
on page 620.
on page 234
on page 620.
Remote commands
on page 705.
717 717