Rohde & Schwarz FPL1000 Manuel D'utilisation page 794

®
R&S FPL1000
SYSTem:COMMunicate:RDEVice:PMETer<p>:CONFigure:AUTO[:STATe] <State>
This command turns automatic assignment of a power sensor to the power sensor
index on and off.
Suffix:
<p>
Parameters:
<State>
Example:
Manual operation:
SYSTem:COMMunicate:RDEVice:PMETer<p>:COUNt?
This command queries the number of power sensors currently connected to the
R&S FPL1000.
Suffix:
<p>
Return values:
<NumberSensors>
Example:
Usage:
Manual operation:
SYSTem:COMMunicate:RDEVice:PMETer<p>:DEFine <Placeholder>, <Type>,
This command assigns the power sensor with the specified serial number to the
selected power sensor index (configuration).
The query returns the power sensor type and serial number of the sensor assigned to
the specified index.
Suffix:
<p>
Parameters:
<Placeholder>
<Type>
<Interface>
<SerialNo>
Manuel d'utilisation 1179.5860.09 - 12
Power sensor index
ON | OFF | 0 | 1
*RST:
SYST:COMM:RDEV:PMET:CONF:AUTO OFF
See "Select"
Power sensor index
Number of connected power sensors.
SYST:COMM:RDEV:PMET:COUN?
Query only
See "Select"
<Interface>, <SerialNo>
Power sensor index
Currently not used
Detected power sensor type, e.g. "NRP-Z81".
Interface the power sensor is connected to; always "USB"
Serial number of the power sensor assigned to the specified
index
Setting basic spectrum RF measurement parameters
1
on page 287
on page 287
Remote commands
794 794