Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Suffix:
<n>
Parameters:
<Margin>
Example:
Manual operation:
CALCulate<n>:PSEarch:PSHow <State>
CALCulate<n>:PEAKsearch:PSHow <State>
This command turns the peak labels in the diagram on and off.
Peak labels are blue squares.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:PSEarch:SUBRanges <NumberPeaks>
CALCulate<n>:PEAKsearch:SUBRanges <NumberPeaks>
This command defines the number of peaks included in the peak list.
After this number of peaks has been found, the R&S FPL1000 stops the peak search
and continues the search in the next measurement range.
Suffix:
<n>
Parameters:
<NumberPeaks>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
Window
Range:
-200 to 200
Default unit: dB
CALC:PSE:MARG 100
Sets the threshold to 100 dB.
See
"Margin"
on page 214
Window
ON | OFF | 1 | 0
*RST:
0
CALC:PSE:PSH ON
Marks all peaks with blue squares.
See
"Show Peaks"
on page 214
Window
Range:
1 to 50
*RST:
25
CALC:PSE:SUBR 10
Sets 10 peaks per range to be stored in the list.
See
"Peaks per Range"
Remote commands
on page 215
697
697
Publicité
