Rohde & Schwarz FPL1000 Manuel D'utilisation page 807

®
R&S FPL1000
[SENSe:]CORRection:TRANsducer:GENerate <Name>
This command uses the normalized measurement data to generate a transducer factor
with up to 1001 points. The trace data is converted to a transducer with unit dB and
stored in a file with the specified name and the suffix .trd under
C:\ProgramData\Rohde-Schwarz\ZNL-FPL\trd. The frequency points are allo-
cated in equidistant steps between start and stop frequency.
The generated transducer factor can be further adapted using the commands descri-
bed in
Parameters:
<Name>
Example:
Manual operation:
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:RVALue <Value>
This command defines the reference value assigned to the reference position in the
specified window. Separate reference values are maintained for the various displays.
Suffix:
<n>
<w>
<t>
Parameters:
<Value>
Example:
Manual operation:
Power sweep commands
The following commands are required to configure a power sweep using an internal
tracking generator.
For an example of performing a power sweep remotely, see
gramming example: measuring compression
Useful commands for power sweeps described elsewhere:
●
OUTPut<up>[:STATe]
●
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:
RPOSition
●
SOURce<si>:INTernal:FREQuency:OFFSet
●
SOURce<si>:POWer[:LEVel][:IMMediate]:OFFSet
Manuel d'utilisation 1179.5860.09 - 12
Chapter 10.10.3, "Working with
'<name>'
CORR:TRAN:GEN 'MyGenerator'
Creates the transducer file
C:\r_s\instr\trd\MyGenerator.trd.
See "Save as Trd Factor"
Window
subwindow
irrelevant
Default unit: DB
DISP:TRAC:Y:RVAL 0
Sets the value assigned to the reference position to 0 Hz
See "Reference Value"
on page 796
on page 776
Setting basic spectrum RF measurement parameters
transducers", on page 962).
on page 303
on page 303
points", on page 629.
on page 798
Remote commands
Chapter 10.6.3.2, "Pro-
on page 797
807 807