Rohde & Schwarz FPL1000 Manuel D'utilisation page 714

®
R&S FPL1000
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<MeanPower>
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN:PHOLd:RESult?
This command queries the maximum mean time domain power. The query is only pos-
sible if the peak hold function has been activated previously using
MARKer<m>:FUNCtion:SUMMary:PHOLd.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<MeanPower>
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN:RESult?
This command queries the mean time domain power.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<MeanPower>
Usage:
Manuel d'utilisation 1179.5860.09 - 12
INITiate<n>:CONTinuous
Window
Marker
Mean power of the signal during the measurement time.
Query only
INITiate<n>:CONTinuous
Window
Marker
Mean power of the signal during the measurement time.
Query only
INITiate<n>:CONTinuous
Window
Marker
Mean power of the signal during the measurement time.
Query only
Configuring and performing measurements
on page 620.
on page 620.
on page 620.
Remote commands
CALCulate<n>:
714 714