Rohde & Schwarz FPL1000 Manuel D'utilisation page 921

®
R&S FPL1000
Example:
CALCulate<n>:LIMit<li>:FAIL?
This command queries the result of a limit check in the specified window.
Note that for SEM measurements, the limit line suffix <li> is irrelevant, as only one spe-
cific SEM limit line is checked for the currently relevant power class.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<li>
Return values:
<Result>
Example:
Usage:
Manual operation:
10.8.10.4 Programming example: using limit lines
The following examples demonstrate how to work with limit lines in a remote environ-
ment.
●
Example: configuring limit lines
●
Example: performing a limit check
Example: configuring limit lines
This example demonstrates how to configure 2 limit lines - an upper and a lower limit -
for a measurement in a remote environment.
//------------- Configuing the limit lines ---------------------
CALC:LIM1:NAME 'FM1'
//Names limit line 1 'FM1'.
CALC:LIM1:CONT:MODE ABS
Manuel d'utilisation 1179.5860.09 - 12
CALC:LIM:CLE
Deletes the result of the limit check.
INITiate<n>:CONTinuous
Window
Limit line
0
PASS
1
FAIL
INIT;*WAI
Starts a new sweep and waits for its end.
CALC2:LIM3:FAIL?
Queries the result of the check for limit line 3 in window 2.
Query only
See "Limit Check <n>"
See "Limit Check"
Setting basic spectrum RF measurement parameters
on page 620.
on page 183
on page 213
.................................................................................... 915
............................................................................... 917
Remote commands
921 921