Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
CONFigure:CMEasurement:RESult:CVALue <UserCompression>
Defines the compression value for the n dB compression point (see
CMEasurement:RESult:PNDB[:STAT]
To query the results of the n dB compression point measurement, use
CMEasurement:PNDB[:RESult]?
Parameters:
<UserCompression> Distance from the linear trace to the reference trace
Example:
Manual operation:
CONFigure:CMEasurement:RESult:P1DB[:STAT] <State>
Enables or disables the calculation of the 1 dB compression point.
To query the results of the 1 dB compression point measurement, use
CMEasurement:P1DB[:RESult]?
Parameters:
<State>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
MANual
The reference value is defined using
CMEasurement:REFerence:VALue
*RST:
AUTO
CONF:CME:REF MAN
CONF:CME:REF:VAL -30
See
"Reference"
on page 131
on page 628).
on page 629.
Default unit: DB
Enable calculation:
CONF:CME:REF:PNDB ON
Define compression value:
CONF:CME:RES:CVAL 5
Query results:
FETC:CME:PNDB?
See
"Compression Points"
on page 629.
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST:
1
Enable calculation:
CONF:CME:REF:P1DB ON
Query results:
FETC:CME:P1DB?
See
"Compression Points"
Remote commands
CONFigure:
on page 626.
CONFigure:
FETCh:
on page 131
FETCh:
on page 131
633
633
Publicité
