Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
This includes:
●
Center frequency
●
Reference level
Example:
Manual operation:
[SENSe:]ADJust:CONFigure:LEVel:DURation <Duration>
In order to determine the ideal reference level, the R&S FPL1000 performs a measure-
ment on the current input data. This command defines the length of the measurement
[SENSe:]ADJust:CONFigure:LEVel:DURation:MODE
if
Parameters:
<Duration>
Example:
Manual operation:
[SENSe:]ADJust:CONFigure:LEVel:DURation:MODE <Mode>
In order to determine the ideal reference level, the R&S FPL1000 performs a measure-
ment on the current input data. This command selects the way the R&S FPL1000
determines the length of the measurement .
Parameters:
<Mode>
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
ADJ:ALL
See
"Adjusting all Determinable Settings Automatically (Auto
All)"
on page 352
Numeric value in seconds
Range:
0.001 to 16000.0
*RST:
0.001
Default unit: s
ADJ:CONF:DUR:MODE MAN
Selects manual definition of the measurement length.
ADJ:CONF:LEV:DUR 5ms
Length of the measurement is 5 ms.
See
"Changing the Automatic Measurement Time (Meastime
Manual)"
on page 353
AUTO
The R&S FPL1000 determines the measurement length auto-
matically according to the current input data.
MANual
The R&S FPL1000 uses the measurement length defined by
[SENSe:]ADJust:CONFigure:LEVel:DURation
on page 759.
*RST:
AUTO
See
"Resetting the Automatic Measurement Time (Meastime
Auto)"
on page 353
See
"Changing the Automatic Measurement Time (Meastime
Manual)"
on page 353
Remote commands
is set to MANual.
765
765
Publicité
