Rohde & Schwarz FPL1000 Manuel D'utilisation page 609

®
R&S FPL1000
10 Remote commands
The commands required to perform measurements in the Spectrum application in a
remote environment are described here.
Compatibility with former R&S signal and spectrum analyzers
As a rule, the R&S FPL1000 supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S FPL1000 can emulate these other devices, including their default values, in
order to repeat previous measurements or support existing control applications as in
legacy systems.
●
Conventions used in SCPI command descriptions
●
Common suffixes
●
Common commands
●
Commands for remote instrument operation
●
Selecting the operating mode and application
●
Configuring and performing measurements
●
Remote commands for result displays
●
Setting basic spectrum RF measurement parameters
●
Managing settings and
●
Configuring the R&S FPL1000
●
Emulating other instruments' commands
●
Using the status register
●
Deprecated commands
10.1 Conventions used in SCPI command descriptions
The following conventions are used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Parameters that are only returned as the result of a query are indicated as Return
values.
●
Conformity
Commands that are taken from the SCPI standard are indicated as SCPI con-
firmed. All commands used by the R&S FPL1000 follow the SCPI syntax rules.
Manuel d'utilisation 1179.5860.09 - 12
Conventions used in SCPI command descriptions
............................................................................................................ 604
...................................................................................................... 604
........................................................................ 743
results...................................................................................... 918
..................................................................................... 959
............................................................................................. 1015
............................................................................................... 1028
Remote commands
................................................... 603
.............................................................. 609
........................................................... 610
............................................................... 618
............................................. 752
.................................................................... 982
609 609