Rohde & Schwarz FPL1000 Manuel D'utilisation page 932

®
R&S FPL1000
●
measurement hardware configuration including markers
●
limit lines
Note that a configuration may include no more than 8 limit lines. This number
includes active limit lines as well as inactive limit lines that were used last.
Therefore the combination of inactivate limit lines depends on the sequence of use
with
●
color settings
●
configuration for the hardcopy output
Parameters:
<State>
Example:
Manual operation:
MMEMory:SELect:CHANnel[:ITEM]:LINes:ALL <State>
MMEMory:SELect[:ITEM]:LINes:ALL <State>
This command includes or excludes all limit lines (active and inactive) when storing or
loading a configuration file.
Parameters:
<State>
Example:
Manual operation:
MMEMory:SELect:CHANnel[:ITEM]:NONE
MMEMory:SELect[:ITEM]:NONE
This command does not include any of the following items when storing or loading a
configuration file.
●
Hardware configuration:
●
Limit lines:
●
Spectrogram data:
●
Trace data:
on page 927
●
Transducers:
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
MMEMory:LOAD:STATe
ON | OFF | 0 | 1
*RST:
MMEM:SEL:HWS ON
See "Items:"
ON | OFF | 1 | 0
*RST:
MMEM:SEL:LIN:ALL ON
See "Items:"
MMEMory:SELect[:ITEM]:HWSettings
MMEMory:SELect[:ITEM]:LINes:ALL
MMEMory:SELect[:ITEM]:SGRam
MMEMory:SELect[:ITEM]:TRACe<1...3>[:ACTive]
MMEMory:SELect[:ITEM]:TRANsducer:ALL
MMEM:SEL:NONE
See "Items:"
Managing settings and results
on page 929.
1
on page 475
0
on page 475
on page 475
Remote commands
on page 925
on page 926
on page 927
on page 928
932 932