Rohde & Schwarz FPL1000 Manuel D'utilisation page 879

®
R&S FPL1000
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:X?
This command queries the position of the peaks on the x-axis.
The order depends on the sort order that has been set with
MARKer<m>:FUNCtion:FPEaks:SORT.
Suffix:
<n>
<m>
Return values:
<PeakPosition>
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:FPEaks:Y?
This command queries the position of the peaks on the y-axis.
The order depends on the sort order that has been set with
MARKer<m>:FUNCtion:FPEaks:SORT.
Suffix:
<n>
<m>
Return values:
<PeakPosition>
Usage:
10.8.8.9 Noise measurement marker
The following commands control the noise measurement marker function.
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:AOFF
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:RESult?
CALCulate<n>:MARKer<m>:FUNCtion:NOISe[:STATe]
CALCulate<n>:MARKer<m>:FUNCtion:NOISe:AOFF
Removes all noise markers in the specified window.
Suffix:
<n>
<m>
Example:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
irrelevant
irrelevant
Position of the peaks on the x-axis. The unit depends on the
measurement.
Query only
irrelevant
irrelevant
Position of the peaks on the y-axis. The unit depends on the
measurement.
Query only
Window
irrelevant
CALC:MARK:FUNC:NOIS:AOFF
Remote commands
CALCulate<n>:
CALCulate<n>:
............................................................. 873
.......................................................... 874
.......................................................... 874
879 879