Rohde & Schwarz FPL1000 Manuel D'utilisation page 583

®
R&S FPL1000
Language
IF Gain
Sweep Repeat
Coupling
Revision String
Resetting the Factory Revision
Language
Defines the system language used to control the instrument.
For details on the available GPIB languages, see
commands of emulated HP
Note: Emulating previous R&S signal and spectrum analyzers. This function is also
used to emulate previous R&S signal and spectrum analyzers.
As a rule, the R&S FPL1000 supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S FPL1000 can emulate these other devices, including their default values, in
order to repeat previous measurements or support existing control applications as in
legacy systems.
Remote command:
SYSTem:LANGuage
IF Gain
Configures the internal IF gain settings in HP emulation mode due to the application
needs. This setting is only taken into account for resolution bandwidth < 300 kHz.
NORM
PULS
This setting is only available if an HP language is selected (see
on page 577).
Remote command:
SYSTem:IFGain:MODE
Sweep Repeat
Controls a repeated sweep of the E1 and MKPK HI HP model commands (for details
on the commands refer to
HP models",
sweeping before.
Note: In single sweep mode, switch off this setting before you set the marker via the
E1 and MKPK HI commands in order to avoid sweeping again.
This setting is only available if a HP language is selected (see
on page 577).
Remote command:
SYSTem:RSWeep
Manuel d'utilisation 1179.5860.09 - 12
............................................................................................................................... 577
.................................................................................................................................... 577
....................................................................................................................... 577
................................................................................................................................. 578
...................................................................................................................... 578
models",
on page 983
Optimized for high dynamic range, overload limit is close to reference level.
Optimized for pulsed signals, overload limit up to 10 dB above reference level.
on page 983
Chapter 10.11.2, "Reference: GPIB commands of emulated
on page 985). If the repeated sweep is OFF, the marker is set without
on page 984
Network operation and remote control
Network and remote control settings
........................................................................................... 578
Chapter 10.11.2, "Reference: GPIB
on page 985.
"Language"
"Language"
583 583