Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
CALCulate<n>:ESPectrum:PSEarch:MARGin <Threshold>
CALCulate<n>:ESPectrum:PEAKsearch:MARGin <Margin>
This command defines the threshold of the list evaluation.
Suffix:
<n>
Parameters:
<Margin>
Example:
Manual operation:
CALCulate<n>:ESPectrum:PSEarch:PSHow <State>
CALCulate<n>:ESPectrum:PEAKsearch:PSHow <State>
This command turns the peak labels in the diagram on and off.
Peak labels are blue squares.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
10.6.7.8
Performing an SEM measurement
The following commands are required to perform an SEM measurement:
●
SENS:SWE:MODE ESP, see
●
INITiate<n>[:IMMediate]
10.6.7.9
Retrieving results
The following commands analyze and retrieve measurement results for SEM measure-
ments.
●
CALCulate<n>:LIMit<li>:FAIL?
●
TRACe<n>[:DATA]
●
TRACe<n>[:DATA]:MEMory?
●
TRACe<n>[:DATA]:X?
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
Window
Range:
-200 to 200
*RST:
200
Default unit: dB
CALC:ESP:PSE:MARG 100
Sets the margin to 100 dB.
See
"Margin"
on page 192
Window
ON | OFF | 1 | 0
*RST:
0
CALC:ESP:PSE:PSH ON
Marks all peaks with blue squares.
See
"Show Peaks"
on page 192
[SENSe:]SWEep:MODE
on page 620
on page 915
on page 829
on page 830
on page 831
Remote commands
on page 653
683
683
Publicité
