Rohde & Schwarz FPL1000 Manuel D'utilisation page 800

®
R&S FPL1000
Example:
Manual operation:
[SENSe:]PMETer<p>:ROFFset[:STATe] <State>
This command includes or excludes the reference level offset of the analyzer for power
sensor measurements.
Suffix:
<p>
Parameters:
<State>
Example:
Manual operation:
[SENSe:]PMETer<p>:SOFFset <SensorOffset>
Takes the specified offset into account for the measured power. Only available if
[SENSe:]PMETer<p>:ROFFset[:STATe]
Suffix:
<p>
Parameters:
<SensorOffset>
Example:
Manual operation:
[SENSe:]PMETer<p>[:STATe] <State>
This command turns a power sensor on and off.
Suffix:
<p>
Parameters:
<State>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
ON | 1
Switches the function on
PMET2:MTIM:AVER ON
Activates manual averaging.
See "Meas Time/Average"
Power sensor index
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
PMET2:ROFF OFF
Takes no offset into account for the measured power.
See "Use Ref Level Offset"
Power sensor index
Default unit: DB
PMET2:TRIG:SOFF 0.001
See "Sensor Level Offset"
Power sensor index
ON | OFF | 0 | 1
OFF | 0
Switches the function off
Remote commands
on page 288
on page 288
is disabled.
on page 288
800 800